Product Overview
LIMITED STOCK AVAILABLE, PLEASE SEE OPTIONS.
RUST SCAT has been re-branded to Coronado Multapply. Click here for new product page.
Rust Scat® Gloss Acrylic Enamel is an interior-exterior finish, which is suitable for coating primed metal, wood or masonry surfaces. It is water thinned so it poses no fire hazard. The acrylic resin provides excellent color and gloss retention as well as tenacious adhesion properties. This durable waterborne coating for use on wood, metal, masonry and drywall in commercial, institutional, industrial and residential applications. Not recommended for unprimed wood and metal, immersion service or high corrosion areas. Do not use as a house paint on wood siding.
- Durable Multi-Purpose Waterborne Enamel
- Excellent Color and Gloss Retention
- Fast Dry
- Superior Leveling
- Suitable for use on USDA inspected facilities
COVERAGE: 350-450sq.ft./gallon
DRY TIMES:
- TO TOCUH: 30 minutes
- TO RECOAT: 2 hours
SURFACE PREPARATION: Surfaces to be painted must be clean, dry, and free of dirt, dust, grease, oil, soap, wax, scaling paint, water soluble materials and mildew. Remove any peeling or scaling paint, and sand these areas to feather edges smooth with adjacent surfaces. Glossy areas should be dulled. Drywall surfaces must be free of sanding dust. Spot prime before and after filling nail holes, cracks, and other surface imperfections. New plaster or masonry surfaces must be allowed to cure (30 days) before applying base coat. Cured plaster should be hard, have a slight sheen and maximum pH of 10; soft, porous or powdery plaster indicates improper cure. Knife off any protrusions and prime plaster before and after applying patching compound. Poured or pre-cast concrete with a very smooth surface should be etched or abraded topromote adhesion, after removing all form release agents and curing compounds. Remove any powder or loose particles. Difficult Substrates: Your dealer offers a variety of specialty primers for use over difficult substrates such as plaster, bleeding woods, grease stains, crayon markings, hard glossy surfaces, galvanized metal or other substrates where paint adhesion or stain suppression is a particular problem. Your dealer can recommend the right problem-solving primer for your special needs.
PRIMING: New surfaces should be fully primed, and previously painted surfaces may be primed or spot primed as necessary.
APPLICATION: Application Stir thoroughly. Make sure that no pigment remains on the bottom of the can and that the entire contents are fluid and free of lumps. Apply by brush, roller or spray. You may thin product with water sparingly to achieve the desired consistency. Apply at temperatures between 50 °F and 100 °F (10 °C – 37.7 °C). Do not apply if temperature is within 5° of dew point or if rain is expected within 12 hours.
Thinning is not recommended. Apply only when surface and air temperatures are between 45 °F and 95 °F (7.2 °C to 35 °C). Do not apply if rain is threatening or if the temperature is within 5 degrees of the dew point and falling.
Cleanup: Water
Resin Type: Acrylic
Recommended Use: Interior or exterior
Colors: Available in thousands of custom colors and the following factory mixed colors:
- White, Black, Terra Cota, Battleship Gray, Sandstone, OSHA Red, OSHA Blue, Mack Green, OSHA Orange, International Orange, OSHA Green, National Blue, OSHA Yellow, Oxford Brown, Silver Gray, Walnut, and Safety Red.
Note: Five gallon pails only available in white and pastel colors.
Click here to view the Benjamin Moore Color Gallery.
VOC Level: < 224 g/L
LIMITATIONS: Rust Inhibitive when used with Rust Inhibitive Primer. Apply at temperatures between 50 °F and 100 °F (10 °C – 37.7 °C). Not intended for immersion service
Reviews
