Product Overview
Rustoleum 2K Epoxy Primer is a true two component, amine cured epoxy aerosol rust inhibitive primer. This unique product contains both components within the aerosol container and are activated prior to use. This primer can be used on clean steel, sound rusted steel, galvanized steel, aluminum, and sound previously coated surfaces. Primer may be wet or dry sanded.
Get the power of a two-component epoxy in the convenience of an aerosol with Rust-Oleum High Performance (VK9300 System) 2K Epoxy Primer Spray. This unique, no-mess formula enhances the performance of any top coat in mild-to-severe environments.
- Exceptional chemical and corrosion resistance; must have for every industrial tool crib
- Easy activation; patented 2K technology; extended pot life of 4 days
- Adheres directly to clean/rusty/galvanized metal, aluminum, painted surfaces, etc.
- Ideal for hard-to-reach areas exposed to corrosion and chemicals like welds, seams, bolts, etc.
- Meets USDA requirements for incidental food contact; accepted for use in federally registered Canadian food facilities; VOC-compliant nationwide
SURFACE PREPARATION: ALL SURFACES: Remove all dirt, grease, oil, salt or other contaminants by washing surface with Industrial Pure Strength® Cleaner/Degreaser, item #3599402, commercial detergent or other suitable cleaner. Rinse thoroughly with fresh water and allow to fully dry. Thoroughly cured previous coatings or bare metal surfaces which are very smooth may require scuff sanding to maximize adhesion. Previously coated surfaces must be sound and in good condition.
MIXING: Use only when air, surface, and material temperatures are between 60°-100°F (15.5°-38°C), and humidity is below 80%. Shake container vigorously for 2 full minutes before activating the epoxy. After shaking remove the red button from the cap and attach it to the pin on the bottom of the container. Invert the aerosol and place it upside down on a hard firm surface. Press down on the red button with your hand until the stop is reached. This action combines the two components and activates the epoxy resin. Shake container vigorously again for 2 full minutes. The coating is now ready for use.
APPLICATION: Protect surrounding surfaces from overspray. Overspray can carry a significant distance. Hold can 10-14 inches from surface. Apply two light coats 2-5 minutes apart to avoid drips and runs. If clogged, remove tip and clean in thinner. Do not insert any object into can valve opening. Remaining product in the container is useable for up to 4 days. This pot life will decrease at higher temperatures. Clean valve immediately after use by turning can upside down and depressing spray button for 3-5 seconds (some paint will be sprayed out, so be careful to not inadvertently spray yourself or other objects). If recoat time exceeds 24 hours, lightly scuff sand the primer prior to application of the topcoat. Properly discard empty container. Do not burn or place in trash compactor. Empty container can be recycled.
Product Videos
Reviews
1 Review Hide Reviews Show Reviews
-
good primer, bad delivery
This sprayed well at first, tip soon clogged. Cleaned tip, clogged again. Splotches resulted. Good primer, just couldn't spray it. Trying Rustoleum Filler Primer now.
