Product Overview
*****FREE SHIPPING*****
A 100% acrylic, interior and exterior primer for all project needs. It combines all the qualities desired in a multipurpose primer: strong adhesion for all surfaces, provides a mildew-resistant coating, quick drying, and low-VOC. Formulated to suppress most light stains.
- 100% acrylic
- Interior/exterior primer
- Strong adhesion to interior and exterior substrates
- Quick drying – 1 hour recoat
- Mildew-resistant
- Low-VOC
- Provides a mildew resistant coating
COVERAGE: 350 - 400 sq.ft. per gallon
DRY TIMES:
- To Touch - 30 minutes
- To Recoat - 1 hour
USAGE:
- Interior
- Previously painted wood
- Plywood
- Drywall
- Ceiling tile
- Formica®
- Masonite®
- Ceramic tile
- Cured plaster
- Wall coverings
- Exterior:
- Previously painted wood
- Aluminum
- Hardboard and vinyl siding
- Shingles
- Shakes
- Concrete
- Masonry
- Stucco
- Brick
- Non-ferrous metal surfaces.
- NOTE: On hard, non-porous surfaces, such as glazed ceramics and non-ferrous metal, maximum adhesion and hardness may take 3-4 days to develop.
Certifications & Qualifications:
- VOC compliant in all regulated areas
- Qualifies for LEED® v4 Credit
- Qualifies for CHPS low emitting credit (Collaborative for High Performance Schools)
- CDPH v1 Emission Certified
- Master Painters Institute MPI # 6, 39, 137, 137 X-Green™
- Class A (0-25) over non-combustible surfaces when tested in accordance with ASTM E-84
- Water Vapor Transmission: ASTM D1653 (method A): 7 perms
Surface Preparation: Surfaces to be painted must be clean, dry, and free of dirt, dust, grease, oil, soap, wax, scaling paint, water soluble materials, and mildew. Remove any peeling or scaling paint and sand these areas to feather edges smooth with adjacent surfaces. Glossy areas should be dulled. Drywall surfaces must be free of sanding dust.
New plaster or masonry surfaces must be allowed to cure before applying base coat. Cured plaster should be hard, have a slight sheen and maximum PH of 10; soft, porous or powdery plaster indicates improper cure. Never sand a plaster surface; knife off any protrusions and prime plaster before and after applying patching compound. Poured or pre-cast concrete with a very smooth surface should be etched or abraded to promote adhesion, after removing all form release agents and curing compounds. Remove any
powder or loose particles before priming. Wood substrates must be thoroughly dry. Caution: Smooth planed clapboards or siding must be sanded thoroughly to break the “mill glaze” allowing proper penetration and adhesion.
Application: Stir thoroughly before and during use. Apply one or two coats. Paint Application: For best results, use a premium nylon/polyester brush, premium roller, or a similar product. Apply paint generously from unpainted area into wet area. This product can also be sprayed.
- Spray, Airless:
- Fluid Pressure: 1500 – 2500
- Tip: .013 - .017
Reviews
